Author Topic: [Solved] Installation issues  (Read 556 times)

mannequin

  • Newbie
  • *
  • Posts: 2
  • Karma: +0/-0
[Solved] Installation issues
« on: Fri Dec 21 15:03:56 2018 »
Hello,

I have tried unsuccessfully to install this a few times. I tried doing as much searching as I could before posting here, but to no avail.

I am having issues with the minimal installer and the graphical installer, both in BIOS and UEFI. This is what I am running into with both from two different installers;

I am trying to install this on a separate SSD that has been formatted and not partitioned. The goal is to have a UEFI dual boot system

What am I missing?

Thanks

Edit: Those two pictures are showing what happens right after booting from the USB.
« Last Edit: Sat Dec 22 16:11:42 2018 by mannequin »

Thierry

  • Administrator
  • Sr. Member
  • *****
  • Posts: 446
  • Karma: +7/-0
  • Gender: Male
    • NuTyX distribution
Re: Installation issues
« Reply #1 on: Sat Dec 22 10:41:01 2018 »
Welcome to NuTyX,

I would like to know what's your hardware Disk Controller.

Can you check in LIVE modus with the command:

Code: [Select]
lspci
And identify the SATA controller.

mannequin

  • Newbie
  • *
  • Posts: 2
  • Karma: +0/-0
Re: Installation issues
« Reply #2 on: Sat Dec 22 15:31:07 2018 »
Hi,

Thanks for the reply

lspci
Code: [Select]
03:00.1 SATA controller: Advanced Micro Devices, Inc. [AMD] X370 Series Chipset SATA Controller (rev 02)
06:00.0 SATA controller: ASMedia Technology Inc. ASM1062 Serial ATA Controller (rev 02)           
12:00.2 SATA controller: Advanced Micro Devices, Inc. [AMD] FCH SATA Controller [AHCI mode] (rev 51)

My problems initially started with the iso’s on this page which I believe to be out of date. After browsing the forums for a bit, I discovered this page for a different set of iso’s. These iso’s are more recently dated.

Using rufus with the new minimal iso, I still ran into the exact same problems. I then tried with the "DD" since that was the one option I hadn’t thought of until later. Rufus setup

I was able to boot (UEFI) in and install NuTyX without much issue.

There is one difference however, there is no “boot” option on the minimal iso. I had to manually install grub. Not that much of an issue.



Now I just need grub to cooperate and dual boot, and I'll be set  :)

Thierry

  • Administrator
  • Sr. Member
  • *****
  • Posts: 446
  • Karma: +7/-0
  • Gender: Male
    • NuTyX distribution
Re: [Solved] Installation issues
« Reply #3 on: Sun Dec 23 12:55:26 2018 »
I think you look for this:

https://youtu.be/dgUXes5fXCU?t=168